Prochem Peak GTX User Manual download pdf (Page 25)

Operations

Components

1. Solution Temp Control Valve

This valve allows the operator to control the

solution temperature by bypassing hot water to the

waste tank, for low temperature cleaning such as

upholstery. Turning the valve counter clockwise

opens the valve. Turning clockwise closes the

valve and has the effect of stopping water from

bypassing.

2. Vacuum Gauge

This gauge indicates in inches of mercury how

much vacuum the system is producing at any given

time.

3. Waste Tank Full Indicator Light

This indicator light is activated when the waste tank

is full. When lit the unit will shutdown protecting the

equipment from damage. This also indicates that

the waste tank must be emptied before the unit can

be brought back in service.

NOTE: Never dispose of waste water in storm drains,

water ways or on ground areas. Always dispose of

waste in accordance with local state and federal laws.

4. Engine High Temperature Shutdown Indicator

This light when activated signals an over heat

condition with the engine. When this occurs, trou-

bleshooting is required.

5. Solution Pressure Gauge

This gauge registers the amount of pressure in the

system.

6. Solution Temperature Gauge

This gauge measures the temperature of the

cleaning solution as it exits the machine.

7. Auxiliary Water Tank Pump Switch

The auxiliary water tank pump switch is used to

actuate an optional fresh water demand pump.

8. Waste Pumpout Switch

This switch actuates the optional waste pumpout.

9. Solution Pump Switch

This switch serves to energize the magnetic clutch

to turn the solution pump on or off. Turn clockwise

for activating the pump and counter clockwise for

deactivating the pump.

10. Choke

The choke is for restricting air to the carburetor,

this enriches the fuel mixture. The primary purpose

is for starting in cold temperatures. When the cable

is pulled out air is restricted, when pushed in the

engine is in run position.

Do NOT run engine with choke pulled out.

11. Ignition Switch

The ignition switch controls the power for the

machine. To turn the machine on, turn solution

pump switch counterclockwise to override and

hold. Turn key clockwise until engine starts and

release. Wait 5 seconds then release override

switch. To stop engine rotate key to OFF position.

12. Throttle

The throttle is used to set the speed of the engine

(rpm). The engine speed (rpm) may be increased

by releasing the collar lock, pushing in the red

button on the end of the handle, and pulling the

handle straight out. Engine speed may be changed

in smaller increments by rotating the throttle handle

clockwise or counter-clockwise. The collar lock can

be tightened to prevent the throttle from slipping

and changing the engine speed.

13. Circuit Breakers

These serve to protect the circuits from electrical

spikes and over loads and protects wires from

damage and fire.

14. Hour Meter

The hour meter records the number of hours the

unit has run. This serves as a time recorder for

servicing the machine.

86325860 PEAK GTX PROCHEM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 139 140

Comments to this Manuals

No comments

Prochem Peak GTX User Manual Page 25

Comments to this Manuals

Related products and manuals for Equipment Prochem Peak GTX